HMI Pad Forums Main Forums ScadaMobile Support Acknowledge button

This topic contains 1 reply, has 2 voices, and was last updated by  John 3 years, 9 months ago. This post has been viewed 1394 times

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #21722

    robinh
    Participant

      Hi,

      I am wondering if I can program the Acknowledge button so that when pressing it, it will send a value to my PLC over modbus tcp.

      Best regards

      #21724

      John
      Keymaster

        Hi robinh,

        This is not currently possible. The acknowledge button only acts on the list of active alarms that have shown on the right panel, but there is no way to access its functionality or value in a programatic way.

        Thanks,

        John

      Viewing 2 posts - 1 through 2 (of 2 total)

      You must be logged in to reply to this topic.

      Copyright © SweetWilliam, S.L 2009-2013. All rights reserved.
      Science and Technology Park of the University of Girona, Emili Grahit, 91 (NarcĂ­s Monturiol building, Office P3-B03) 17003-Girona. Phone +34972183244