HMI Pad › Forums › Old forum › Support (old) › Extra Memory (EM) Omron

This topic contains 3 replies, has 2 voices, and was last updated by  jaccov 7 years, 7 months ago. This post has been viewed 1330 times

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 28 May, 2013 at 21:51 #19859

    jaccov
    Participant

      How do I have to read an EM adres from an omron plc

      for example:

      E1_00250 I try this but I think the underscore is not good?

      If I try E0250 it E0_0250

      Regards,
      Jacco

      29 May, 2013 at 7:11 #19860

      John
      Keymaster

        Hi Jacco,

        Only the default EM area is supported, this is usually E0 and it is specified by a single E in ScadaMobile, for example E250 (or E0250 which is the same).

        Thanks

        29 May, 2013 at 15:30 #19861

        jaccov
        Participant

          Do you have plans to update it, with the other area’s

          1 June, 2013 at 9:01 #19862

          John
          Keymaster

            We may add this in the future. Thanks for suggesting it.

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)

          You must be logged in to reply to this topic.

          Copyright © SweetWilliam, S.L 2009-2013. All rights reserved.
          Science and Technology Park of the University of Girona, Emili Grahit, 91 (Narcís Monturiol building, Office P3-B03) 17003-Girona. Phone +34972183244