This topic contains 1 reply, has 1 voice, and was last updated by  John 6 years, 6 months ago. This post has been viewed 1293 times

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #20033

    John
    Keymaster

      Can your apps be used to directly (without any additional communication board) connect iPad2 with Baldor AC Microdrive VS1ST that supports Modbus RTU protocal? Your help will be greatly appreciated

      #20034

      John
      Keymaster

        Yes, the app supports a ‘rtu_mode’ mode for the modbus protocol. This mode embeds serial modbus frames into TCP. Since the rtu is a serial communication protocol you will need an ethernet to serial converter physically wired to your drive on the serial side. The ethernet to serial converter can be a simple one, it does not need to be a modbus/TCP to modbus/RTU converter.

      Viewing 2 posts - 1 through 2 (of 2 total)

      You must be logged in to reply to this topic.

      Copyright © SweetWilliam, S.L 2009-2013. All rights reserved.
      Science and Technology Park of the University of Girona, Emili Grahit, 91 (NarcĂ­s Monturiol building, Office P3-B03) 17003-Girona. Phone +34972183244