HMI Pad Forums Main Forums ScadaMobile Support omron PLC tagging

This topic contains 1 reply, has 2 voices, and was last updated by  John 5 years, 6 months ago. This post has been viewed 1303 times

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #21515


      Hi there, had just purchased the full version of the software and wanted to check is it possible use the tag name of the description instead of using its address like DM0?

      In the excel file, what should be written in the code to denote tags?

      The new NJ series Plc uses tag link instead of addressing.




        For the new NJ you can use the Ethernet/IP Native protocol (Allen Bradley) in the app. The new NJ controllers from Omron are compatible with that protocol that uses symbolic names instead of addresses.


      Viewing 2 posts - 1 through 2 (of 2 total)

      You must be logged in to reply to this topic.

      Copyright © SweetWilliam, S.L 2009-2013. All rights reserved.
      Science and Technology Park of the University of Girona, Emili Grahit, 91 (NarcĂ­s Monturiol building, Office P3-B03) 17003-Girona. Phone +34972183244