HMI Pad Forums Main Forums ScadaMobile Support Use of router gateway

This topic contains 1 reply, has 1 voice, and was last updated by  gjozwa 49 years, 11 months ago. This post has been viewed 622 times

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #19539

    gjozwa
    Member

      My wireless router uses a gateway to access the PLC network, which is on a different subnet. Trials of modifying the PLC IP address structure to match router works a treat, however not a long term solution. Router won't change IP address to PLC structure. Can the SCADAMobile file contain a gateway as well as just the IP adress, if so what is the syntax required.

      #19540

      John
      Keymaster

        Hi, the ScadaMobile app do not handle gateways because it is the initiator or communications. You must enter an IP that would reach your PLC either directly or through your gateway.
        If you are on the same network this is the PLC IP, otherwise use your gateway address and setup it to forward messages to your PLC, or make your gateway to appropriately forward your messages to the PLC subnet, this requires your PLC to be configured with your gateway address as well.
        I hope this answer your question.
        Thanks

      Viewing 2 posts - 1 through 2 (of 2 total)

      You must be logged in to reply to this topic.

      Copyright © SweetWilliam, S.L 2009-2013. All rights reserved.
      Science and Technology Park of the University of Girona, Emili Grahit, 91 (NarcĂ­s Monturiol building, Office P3-B03) 17003-Girona. Phone +34972183244