Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Modbus RTU to Modbus TCP Question #21677

    iMapleInc
    Participant

      gregM,

      Thank you again for all your assistance. I am starting on my 1st HMI Pad project today. I was hoping you could clarify something, if you have more then one remote building each one with (1) identical system (1 controller like the one on your school project) with the same Modbus points etc, can you create (1) HMI project and apply it to multiple sites? Each site would have a separate IP address and password, but could same project access code be utilized by multiple sites / customers to access (1) “standard” project?

      Thanks

      in reply to: Modbus RTU to Modbus TCP Question #21673

      iMapleInc
      Participant

        gregM,

        Thank you. I am using a very similar controller as the Datanab you referenced etc… I only have (1) controller per building / gateway for my current application, but I was wondering how many of the Datanab devices were you able to connect to (1) NET485 module & effectively display on the HMI app?

      Viewing 2 posts - 1 through 2 (of 2 total)
      Copyright © SweetWilliam, S.L 2009-2013. All rights reserved.
      Science and Technology Park of the University of Girona, Emili Grahit, 91 (NarcĂ­s Monturiol building, Office P3-B03) 17003-Girona. Phone +34972183244